KingMade

PRODUCT INFORMATION

Blue/Yellow Green Stuff is a room-temperature curing two-part epoxy putty sold either in tape format. 

Mixing equal parts of the yellow 'filler' and blue 'hardener' produces a sticky green putty that feels a lot like chewed bubble gum. Once mixed, it has a worklife of 90 minutes, allowing time for shaping and detailing, reaching 'ultimate hardness' after 24 hours. Altering the mix with more blue or yellow component will produce a faster/slower and harder/softer cure.

We recommend to use a little lubricant to prevent Green Stuff from sticking. Normally water is enough but some people also use others such as Vaseline, petroleum jelly or even jhonson baby oil to get smooth surfaces. Keep wet fingers and tools to make easier the sculpting and modeling process. You may also add talcum powder to reduce the stickiness and avoid fingerprints.

Milliput

Each package contains two separate bars, one of which is a hardener. Upon mixing an equal quantity of each different bar the material starts to harden, and hardens fully in 90 minutes, after which it can be carved, sanded, drilled, and sculpted over.

Milliput White is similar to Milliput Standard but much more suitable to get finer and smaller detailed pieces in all kind of applications.

If you are interrupted while you are mixing Milliput, you can put the Milliput into a deep freezer until you can get back to work. This will keep the product at approximately the same state of setting at which it was frozen for up to 24 hours

OTHER ADVANTANGES:

-        In combination with water will allow to get extra smooth surfaces.

-        It allows you easily to merge new layers of milliput over

-        It will not get stuck to your either your fingers or your tools

-        Once dried, it can be carved, sanded and drilled

-        Once dried, it remains very hard and resistance. You may mix it with Plasticine or other clays to save putty reducing it hardness.

-        Heat resistance up to 130ºC.

Procreate Putty

New generation of sculpting putty formulated by and for professional artist to create original miniature sculptures. Like all epoxy putties you mix the two components and it will little by little harden. ProCreate has a fine, non-grainy consistency that makes it easy to mix, sculpt, smooth and allows for extremely fine detail.

Grey is also the colour of a finished miniature made of this putty avoiding having colour perspective shift that can make you think things are the wrong size.It is less sticky than green stuff, that means that less lubrication is required for the tools but also a little less adherence to the model, and it has very little shape memory, which is the tendency to return to its original shape if pulled, squashed or twisted. Curing time modifications:• Place the mixed ProCreate in the freezer to stop hardening.• Place the mixed ProCreate under a warm lamp (95ºF / 35ºC max – oven recommended) to speed the hardening process.• Thin sections will cure more slowly

This Set contains 90 gr NET.